|
|
Airworthiness Directives
NOTE - This AD note listing is intended as a guide only and
should not be relied upon as conclusive evidence of AD applicability on
any particular aircraft. Entire Airworthiness Directives may be accessed
at: http://rgl.faa.gov.
Showing Results 2981 - 3000 of 5103
| View All
< Previous |
145
|
146
|
147
|
148
|
149
|
150
|
151
|
152
|
153
|
154
| Next >
| AD No. |
MAKE |
Condensed description of ad note |
| 86-19-13 |
Avco Lyc |
Penetrant inspect turbine disks | T5508D eng |
| 86-19-12 |
Allison |
Supersedes 84-24-2 | rework engine, install shields | 250-C30 series |
| 86-19-11 |
Cessna |
Modify fuel quick-drain sys | R172 thru R172K; 177,177B,177RG; 185 thru 15E, A185E,F; A188A,B,T188C; 205,A; 206,U,TU thru G, TP, P206; 207,T207,-A;210B, T thru R, P210N,R |
| 86-19-10 |
Mooney |
Supersedes 76-15-1 | perform wood structure load test each 12 months | M20,-A |
| 86-18-5 |
Avco Lyc |
Superseded by 86-22-8 |
| 86-18-2 |
Beech |
Superseded by 87-23-9 |
| 86-18-10 |
Piper |
Detail inspect wing tip tank vent lines | PA-42-1000 (thru SN -5527033) |
| 86-17-9 |
Bell |
Inspect T/R trunion bearing housing | 212 (SN 30501 thru 32262) |
| 86-17-7 |
Piper |
Superseded by 96-21-4 |
| 86-17-3 |
Aerospatiale |
Modify elevator tab control system | Trindad TB20 (all thru SN 479) |
| 86-17-2 |
Hiller |
Supersedes 79-18-4 | inspect/replace rotor blade fork P/N 52110-3 | UH-2D, E1 |
| 86-17-12 |
Bell |
Superseded by 87-13-1 |
| 86-17-11 |
Maule |
Inspect fuel crossover line | M-5-180C (thru SN 8021C), M-5-201C (thru SN 6206C), M-5-220C (thru SN 5057C), M-5-235C (thru SN 7052C) |
| 86-17-10 |
Bell |
Inspect T/R trunion bearing housing | 205, 205A-1 |
| 86-17-1 |
Piper |
Supersedes 80-24-3 | replace ammeter(s) | PA-28-150, -160, -180, -181, -235, -236, -201T; -28R-180, -200; 201, 201T; -28RT-201; PA32-260, -300; -32R-300; RT-300,-300T; -32-301,- 301T; -32R-301, -301T; PA-34-200T |
| 86-16-3 |
Allison |
Check oil consumption, install #8 bearing scavenge line assembly | 250-C28B, C |
| 86-16-11 |
Bell |
Inspect T/R hub | 412 (SN 33001 thru 33121) |
| 86-15-8 |
deHavilland |
Modify tail attach brackets per Mod 6/1808 & 6/1809 | DHC-6 (SN 3 thru 820) |
| 86-15-7 |
Cessna |
Modify CG if eng larger than O-200-A (perhaps limit to pilot only) | 150 thru 150C |
| 86-15-6 |
Falcon |
Modify rudder servo | approx cost $120 | 10 (SN 1 thru 201) |
Showing Results 2981 - 3000 of 5103
| View All
< Previous |
145
|
146
|
147
|
148
|
149
|
150
|
151
|
152
|
153
|
154
| Next >
|
