92-9-5 |
Bell Heli |
Replace eng-to-transmission driveshaft adapter if fretting; overhaul combining gearbox if eng output drive splines are fretting | 212 & 412 |
92-8-7 |
Beech |
Superseded by 95-4-3 |
92-8-4 |
Piper |
Supersedes 90-17-4 | repetitively inspect & treat cracked/corroded aluminum rudder torque tube fitting until replaced w/steel | PA34-200,-T; PA34-220T |
92-8-15 |
Mooney |
Lower gross weight limit so rudder static balance complies w/SB M20-252 | M20J |
92-7-8 |
Bell Heli |
Replace swashplate support asmbly if flange bushing diameter is excessive | 204B,-A,-A1, 205B, 212 |
92-7-5 |
Beech |
Supersedes 91-12-12 | if draining moisture improperly, modify rudder trim tab | 90; A90; C90,-A; E90; 99,-A; A99A; B99; C99; 100; A100; B100 |
92-7-3 |
BAe |
Install improved wash basin water tank shroud drain outlet | 125-800A |
92-7-14 |
Air Tractor |
Inspect & replace/repair corroded wing spar caps | AT-300;-301;-302; -400,-A |
92-6-8 |
Gen Am |
Stop drill or replace elevator if spar cracked; balance elevator | GA-7 Cougar |
92-6-5 |
BAe |
Revised 4-21-92 | inspect/repair damaged nose landing gear bay sidewalls | DH/BH/HS/BAe 125 series |
92-6-4 |
BAe |
Install & test improved dimmer unit | -800A |
92-6-17 |
Robinson |
Replace bolts in tail rotr blade cntrl asmbly & cabin lower aft corners | R22 series |
92-6-12 |
Bell Heli |
Replace specified sungears & pinion spur gears w/pitted teeth | 206-A,-B,-L,-L1,-L3 |
92-6-11 |
Beech |
Modify A/P-FD wiring & of Collins EFIS-85/86B hardware | 350,300,B300C |
92-4-9 |
Teledyne Cont Eng |
Supersedes 92-2-20 | rework cylinder assembly per SB M92-4; retorque rocker arm shaft hold-down stud nut if assembly complies | Cessna 337, T337, P337, 172XP; Mooney M20K; Piper PA34-200T,-220T, PA28R-201T, PA28RT-201T |
92-4-2 |
Falcon |
If clogged, modify drain stub heating system | 900 series |
92-3-6 |
Canadair |
Superseded by 92-13-9 |
92-3-13 |
Bell Heli |
Superseded by 97-7-6 |
92-27-9 |
BAe |
Replace noted main landing gear parts | BAe/HS/DE/BH 125 series (not -100A) |
92-27-8 |
Cessna |
Replace cracked/worn inboard attach fittings of elevator torque tubes | 650 |